NEW PRODUCTS
Alinco DJ-V17/47T/E DJ-V27T DJ-S17/S47 E
The IEC 60529/IPX7 is an European system of test specification standards for classifying the degrees of protection provided by the enclosures of electrical equipment. An IPX7 designation means that the unit withstands immersion in one meter (approx 3ft) of still water for up to 30 minutes.The factory guarantees this grade for 1 year provided all the jack covers are properly and securely closed. However, Please understand that unit is not an IPX8 (water-resistant) grade, NOT even IPX7 COMPLIANT (but compatible); water-pressure such as washing the unit with running water may cause damage to the unit and voids warranty. Never immerse the unit uselessly under the water. V/UHF signal does not propagate in water.If the unit is dropped in water, please pick it up immediately and wipe with a clean dry cloth.
The \\\"new generation\\\" DJ-V&S17/27/47 is loaded with features, including:
- New, two-touch repeater access
- High grade waterproof materials compatible to IPX7* (submersible 1m/3ft. for 30 min.)
- Rugged polycarbonate body resists dirt, dust and moisture
- Highly visible backlit alphanumeric display
- Direct frequency input through illuminated keypad (V-models only)
- DTMF Autodialer with Memory includes nine autodial memories plus redial function (V-models only)
200 Memories and one call channel
- VFO, Memory and Scan modes
- Ultra-flexible antenna with SMA connector avoids breakage
- 39 CTCSS tone squelch (encode+decode) settings
- Tone burst function (1,000, 1450, 1750 and 2100Hz)
- Battery-drain function avoids memory-effect
- Ergonomic design, fits in the palm of your hand
- Wire cloning capability
- Ni-MH standard and varieties of optional batteries including Li-ION packs
- 2-level attenuator
- Waterproof single mic/speaker jack
- New, two-touch repeater access
- High grade waterproof materials compatible to IPX7* (submersible 1m/3ft. for 30 min.)
- Rugged polycarbonate body resists dirt, dust and moisture
- Highly visible backlit alphanumeric display
- Direct frequency input through illuminated keypad (V-models only)
- DTMF Autodialer with Memory includes nine autodial memories plus redial function (V-models only)
200 Memories and one call channel
- VFO, Memory and Scan modes
- Ultra-flexible antenna with SMA connector avoids breakage
- 39 CTCSS tone squelch (encode+decode) settings
- Tone burst function (1,000, 1450, 1750 and 2100Hz)
- Battery-drain function avoids memory-effect
- Ergonomic design, fits in the palm of your hand
- Wire cloning capability
- Ni-MH standard and varieties of optional batteries including Li-ION packs
- 2-level attenuator
- Waterproof single mic/speaker jack
| Frequency range: |
DJ-V17 / S17 T: TX144 - 147.995MHz RX130 - 173.995MHz E: TX/RX 144 - 145.995MHz DJ-V27T T: TX222 - 224.995MHz RX216 - 249.995MHz DJ-V47 / S47 T: TX430 - 449.995MHz RX410 - 470MHz approx. E: TX/RX 430 - 439.995MHz |
| Modulation: |
F3E (FM) |
| Frequency step: |
5,10, 12.5, 15, 20, 25, 30kHz step |
| Memory channel: |
200 channels + 1 call channel + 1 Repeater-Access parameter memory |
| Antenna impedance: |
50ohm unbalanced |
| Frequency stability: |
DJ-V17 / S17: +/- 5ppm DJ-V27/V47 / S47: +/- 2.5ppm |
| Supply voltage: |
DC 7.0 - 16.0V (EXT DC-IN) |
| Current consumption: (Typical value) |
TX at High power V/S17 1.4A, V27T 1.6A, V/S47 1.7A RX at 500mW AF out: 250mA Stand-by: V/S17 70mA, V27T 80mA, V/S47 80mA Battery-save ON: average 26mA |
| Temperature range: |
Unit -10digC to 60digC (+14digF to +140digF) Battery packs: -10digC to +45digC (+14digF to +113digF) |
| Ground: |
Negative |
| Dimensions: |
58(W)x110(H)x36.4(D)mm (2.28"(W)x4.33"(H)x1.43"(D)) with EBP-65N w/o projection |
| Weight: |
Approx.280g (9.9oz) with EBP-65N & antenna |
| Transmitter |
|
| Power output: (Approx.value) |
V/S17: 5W (with EBP-65N) 5W (with DC 13.8V) 0.8W (LOW output) V27T: 5W (with EBP-65N) 5W (with DC 13.8V) 0.8W (LOW output) V/S47: 4.5W (with EBP-65N) 5W (with DC 13.8V) 0.8W (LOW output) |
| Modulation: |
Variable reactance |
| Spurious emission: |
-60dB or less |
| Max. deviation: |
+/- 5KHz |
| Mic. impedance: |
2Kohm |
| Receiver |
|
| System: |
Double-conversion super heterodyne |
| Sensitivity: |
-14.0dBu (0.2uV) or less |
| Intermediate frequency: |
DJ-V/S17: 1st IF 21.7MHz 2nd IF 450kHz DJ-V/S47 & V27T: 1st IF 38.85MHz 2nd IF 450kHz |
| Selectivity: |
-6dB: 12kHz or more -60dB: 26kHz or less |
| AF output: |
500mW (MAX) / 400mW (8ohm, 10% distortion) |
| Specifications subject to change without notice or obligation. Specifications apply to Amateur Radio bands only. Permits required for MARS use. Product intended for use by properly licensed operators. | |
File belum tersedia
